|
Quantity
|
Out of stock
|
||
|
|
|||
Auger concrete S & R SDS-max VERSIO system used for fast drilling holes in concrete, masonry, natural stone
Auger S & R VERSIO used with:.
- adapter VERSIO
- extension VERSIO
When performing drilling operations must be lubricated shank tool.
When drilling holes deeper than 450 mm using prefabricated systems necessary to perform pre-drilling drills of small length at a depth of not less than 150 mm after why use a longer tool. This will not only protect the instrument from damage, but also increase the speed of drilling, because the energy of the impact on the used power is transmitted to the drill tip with minimal losses. As a result, pilot drilling is fast and accurate, and the hole drilling - the most productive due minimum manifestation of the effect of vibration and a correct impact energy distribution of power in the system
When drilling to a depth of 450 mm in the horizontal plane, especially vertical plane. downwardly periodically necessary to carry out the reverse movement along the (partial extension) of the tool from the hole in order to eliminate the slag accumulated in the hole. This will speed up the process of removing the slag from the hole, and hence increase the productivity of the drilling tool.