Quantity
|
Out of stock
|
||
|
Product type | Single relay |
Set comprises | 2967620 PLC-RSC- 24DC/21HC |
2967633 PLC-RSC- 24UC/21HC | |
2967646 PLC-RSC- 48DC/21HC | |
2912277 PLC-RSP- 24DC/21HC | |
2912280 PLC-RSP- 24UC/21HC | |
2912293 PLC-RSP- 48DC/21HC | |
2900291 PLC-RPT- 24DC/21HC | |
2900293 PLC-RPT- 24UC/21HC | |
2900294 PLC-RPT- 48DC/21HC | |
2834326 PR1-RSC3-LDP-24DC/21 | |
2834407 PR1-RSP3-LDP-24DC/21 | |
2903342 RIF-1-RPT-LDP-24DC/1X21 | |
2903358 RIF-1-RSC-LDP-24DC/1X21 | |
Operating mode | 100% operating factor |
Mechanical service life | 3x 107 cycles |
Insulation characteristics | |
Overvoltage category | III |
Pollution degree | 3 |
Service life electrical | see diagram |
Maximum power dissipation for nominal condition | 0.41 W |
Test voltage (Winding/contact) | 5 kV AC (50 Hz, 1 min., winding/contact) |
Coil side | |
Nominal input voltage UN | 24 V DC |
Input voltage range | 15.6 V DC ... 57.6 V DC |
Typical input current at UN | 17 mA |
Typical response time | 7 ms |
Typical release time | 3 ms |
Coil resistance | 1440 Ω ±10 % (at 20 °C) |
Switching | |
Contact type | 1 changeover contact |
Type of switch contact | Single contact |
Drive and function | monostable |
Drive (polarity) | bipolar |
Contact material | AgNi |
Maximum switching voltage | 250 V AC/DC |
Minimum switching voltage | 12 V (at 10 mA) |
Limiting continuous current | 16 A |
Maximum inrush current | 50 A (20 ms) |
Min. switching current | 10 mA (at 12 V) |
Interrupting rating (ohmic load) max. | 384 W (at 24 V DC) |
58 W (at 48 V DC) | |
48 W (at 60 V DC) | |
50 W (at 110 V DC) | |
80 W (at 220 V DC) | |
4000 VA (for 250 V AC) | |
Switching capacity | 2 A (at 24 V, DC13) |
0.2 A (at 110 V, DC13) | |
0.2 A (at 250 V, DC13) | |
6 A (at 24 V, AC15) | |
6 A (at 120 V, AC15) | |
6 A (at 250 V, AC15) | |
Motor load according to UL 508 | 1/2 HP, 120 V AC (N/O contact) |
1 HP, 240 V AC (N/O contact) | |
1/3 HP, 120 V AC (N/C contact) | |
3/4 HP, 240 V AC (N/C contact) | |
1/4 HP, 200 ... 250 V AC |
Connection method | Plug / solder connection |
Dimensional drawing | |
Width | 12.7 mm |
Height | 29 mm |
Depth | 15.7 mm |
Ambient conditions | |
Degree of protection | RT II |
Ambient temperature (operation) | -40 °C ... 85 °C |
Ambient temperature (storage/transport) | -40 °C ... 85 °C |
Corrosive gas test | |
Identification | ISA-S71.04. G3 Harsh Group |
EN 60068-2-60 |
Standards/regulations | IEC 60664 |
EN 50178 | |
EN 61810-1 |
Assembly instructions | Can be aligned without spacing (> 70 °C ≥ 2.5 mm) |
Mounting position | any |