Quantity
|
Out of stock
|
||
|
Product type | Single relay |
Application | Forcibly guided contacts |
Operating mode | 100% operating factor |
Mechanical service life | approx. 107 cycles |
B10d | 600000 Cycles (AC1; 250 V / 6 A; 1 NO) |
900000 Cycles (AC1; 250 V / 3 A; 1 NO) | |
1800000 Cycles (AC1; 250 V / 1,5 A; 1 NO) | |
180000 Cycles (AC15; 250 V / 3 A; 1 NO) | |
560000 Cycles (AC15; 250 V / 2 A; 1 NO) | |
4600000 Cycles (AC15; 250 V / 0,75 A; 1 NO) | |
360000 Cycles (DC13; 24 V / 3 A; 1 NO) | |
740000 Cycles (DC13; 24 V / 1,5 A; 1 NO) | |
4200000 Cycles (DC13; 24 V / 0,75 A; 1 NO) | |
Insulation characteristics | |
Insulation | Safe isolation, reinforced insulation |
Insulation characteristics: Air clearances and creepage distances between the power circuits | |
Insulation | Safe isolation, reinforced insulation |
Overvoltage category | III |
Pollution degree | 2 |
Maximum power dissipation for nominal condition | 0.7 W |
Air clearances and creepage distances between the power circuits | |
Rated insulation voltage | 250 V AC |
Rated surge voltage | 6 kV |
Coil side | |
Nominal input voltage UN | 24 V DC |
Input voltage range | 19.2 V DC ... 26.4 V DC |
Input voltage range in reference to UN | see diagram |
Typical input current at UN | 29 mA |
Typical response time | 10 ms |
Typical release time | 4 ms |
Switching | |
Contact type | 2 changeover contacts, forcibly actuated |
Type of switch contact | Single contact |
Drive and function | monostable |
Drive (polarity) | bipolar |
Contact material | AgNi |
Maximum switching voltage | 250 V AC/DC |
Minimum switching voltage | 15 V |
Limiting continuous current | 6 A |
Maximum inrush current | 6 A |
Min. switching current | 10 mA (5 V) |
Interrupting rating (ohmic load) max. | 144 W (24 V DC) |
288 W (48 V DC) | |
88 W (110 V DC) | |
110 W (220 V DC) | |
1500 VA (250 V AC) | |
Switching capacity min. | 0.24 W |
Switching capacity | 2 A (24 V (DC13)) |
3 A (230 V (AC15)) | |
Motor load according to UL 508 | 10 LRA / 0,5 FLA |
Connection method | Plug / solder connection |
Width | 12.6 mm |
Height | 29 mm |
Depth | 25.5 mm |
Ambient conditions | |
Degree of protection | IP20 |
Ambient temperature (operation) | -25 °C ... 70 °C |
Ambient temperature (storage/transport) | -25 °C ... 70 °C |
Corrosive gas test | |
Identification | ISA-S71.04. G3 Harsh Group |
EN 60068-2-60 |
Air clearances and creepage distances between the power circuits | |
Standards/regulations | DIN EN 50178 |
DIN EN 61810-3 | |
IEC 60664-1 |