Количество
|
Стоимость
|
||
|
Вставное миниатюрное силовое реле с многослойным золотым контактом, 1 переключающий контакт, входное напряжение 24 В DC
Преимущества для Вас:
- Безопасная развязка между обмоткой и контактом согласно DIN EN 50178
- Высокая степень защиты, до RT III в зависимости от типа (защита от брызг)
- Силовые контакты до 6 А
Product type |
Single relay |
Operating mode |
100% operating factor |
Mechanical service life |
2x 107 cycles |
Insulation characteristics |
|
Overvoltage category |
III |
Pollution degree |
3 |
Electrical properties
Maximum power dissipation for nominal condition |
0.17 W |
Test voltage (Winding/contact) |
4 kV AC (50 Hz, 1 min., winding/contact) |
Input data
Coil side |
|
Nominal input voltage UN |
24 V DC |
Input voltage range |
14.4 V DC ... 66 V DC |
Input voltage range in reference to UN |
see diagram |
Drive and function |
monostable |
Drive (polarity) |
non-polarized |
Typical input current at UN |
7 mA |
Typical response time |
5 ms |
Typical release time |
2.5 ms |
Coil resistance |
3390 Ω ±10 % (at 20 °C) |
Output data
Switching |
|
Contact switching type |
1 changeover contact |
Type of switch contact |
Single contact |
Contact material |
AgSnO, hard gold-plated |
Maximum switching voltage |
30 V AC |
36 V DC |
|
Minimum switching voltage |
100 mV (at 10 mA) |
Limiting continuous current |
50 mA |
Maximum inrush current |
50 mA |
Min. switching current |
1 mA (at 24 V) |
Interrupting rating (ohmic load) max. |
1.2 W (at 24 V DC) |
Switching: when the gold layer is destroyed |
|
Note |
the following values are applicable if a gold layer is destroyed |
Contact material |
AgSnO |
Maximum switching voltage |
250 V AC |
Minimum switching voltage |
5 V (at 100 mA) |
Limiting continuous current |
6 A |
Min. switching current |
10 mA (at 12 V) |
Interrupting rating (ohmic load) max. |
140 W (at 24 V DC) |
20 W (at 48 V DC) |
|
18 W (at 60 V DC) |
|
23 W (at 110 V DC) |
|
40 W (at 220 V DC) |
|
1500 VA (for 250˽V˽AC) |
|
Switching capacity |
2 A (at 24 V, DC13) |
0.2 A (at 110 V, DC13) |
|
0.1 A (at 220 V, DC13) |
|
3 A (at 24 V, AC15) |
|
3 A (at 120 V, AC15) |
|
3 A (at 230 V, AC15) |
Connection data
Connection method |
Plug / solder connection |
Dimensions
Dimensional drawing |
|
Width |
5 mm |
Height |
28 mm |
Depth |
15 mm |
Material specifications
Color |
white (RAL 9010) |
Environmental and real-life conditions
Ambient conditions |
|
Degree of protection |
RT III |
Ambient temperature (operation) |
-40 °C ... 85 °C |
Ambient temperature (storage/transport) |
-40 °C ... 85 °C |
Approvals
Corrosive gas test |
|
Identification |
ISA-S71.04. G3 Harsh Group |
EN 60068-2-60 |
Standards and regulations
Standards/regulations |
IEC 60664 |
EN 50178 |
|
EN 61810-1 |
Mounting
Assembly instructions |
in rows with zero spacing |
Mounting position |
any |